Tinker Bot Air Frame - PRE SALE
Welcome to the future of micro drone platforms, designed for 20+ minutes of flight using our High Amperage Lithium Ion Packs this platform is more than just an acrobatic power house with an over 8-1 thrust ratio- it provides an expandable platform built around a Raspberry Pi(shown with an HD Camera attached) this allows a new world of possibilities in low cost unmanned aerial systems, all while providing a stable and safe platform to experiment on.
This frame is sold with just the basic FPV camera mount, and a carbon top plate with mounting holes for a Raspberry Pi Zero for platform fun.
With Raspberry Pi support and ease of adding in external modules makes this the perfect platform to tinker with, allowing a whole new realm of possibilities only limited by your imagination. We hope to showcase a few of these ideas in the near future- so stay tuned for the magic.
How safe is it? This drone is finger safe- in our testing at worst it will cause a paper cut. Weighing in under 180 grams, it is lighter than a stick of butter. This new smaller category of UAS opens up the skies under new rules and regulations, allowing this to be flown for commercial use over crowds without FAA approved safety features or authorization- so any Part 107 pilot can fly it over crowds legally
- 1x Top Plate
- 1x Bottom Plate
- 1x X Brace
- 1x GPS Mount
- 1x VTX Antenna Mount
- 1x Left Camera Mount
- 1x Right Camera Mount
- 4x Raspberry Pi Standoffs
- 4x Four Tinker Bot Air Arms
- 4x M2.5x5mm Steel Button Head Screws
- 4x M2.5 Nuts
- 8x M2x12mm Steel Button Head Screws
- 16x M2x7mm Steel Button Head Screws
- 4x M3x20mm Black Aluminum Standoffs
- 4x M3x25mm Black Aluminum Standoffs
- 4x M3x30mm Black Aluminum Standoffs
This is a pre-sale item to be shipped end of December 2020.